Check my roof

How it works

A careful process, not a cover-up

Every RoofLift project follows the same four steps. It starts with an honest look at your roof and ends with a fresh colour and a new protective layer.

1

Assess

We look at your roof’s condition from your photos and an on-site visit, then give you a clear recommendation. If repair or replacement is the better choice.

Illustration: a technician on a secured ladder inspecting faded brown shinglesIllustration
2

Prepare

We clear leaves, debris and loose granules and clean the surface so the coating bonds properly. We never pressure wash, because high pressure strips the protective granules from shingles.

Illustration: a harnessed worker clearing leaves from a shingle roof with a backpack leaf blowerIllustration
3

Recolour & protect

We apply a protective coating made for asphalt shingles, in the colour you choose. It goes on in two coats, following the manufacturer’s specifications and in the right weather.

Illustration: a spray gun applying charcoal coating over faded brown shinglesIllustration
4

Review

We inspect the finished roof with you, explain how to care for it and give you the coating manufacturer’s written warranty.

Illustration: a technician reviewing a finished charcoal roofIllustration

Safety

Safety on every roof

Our crews wear full-body harnesses, tie off to secure anchors and use secured ladders. Roof work is dangerous, so please don’t attempt it yourself.

Illustration: two harnessed workers tied off to a roof anchorIllustration

Find out if your roof qualifies

Check my roof
Check my roof